|
Re: Labview servo programming
I don't understand your issue fully, but my suggestion would be to open the LV vision example for the gimbal mounted, servo controlled camera. There is one for single color tracking, and one for the pink/green target. They require that you have the driver station connected and enabled, that you have the digital side car connected to slot four and power, that you have the jumpers on the correct PWM channels, and that you set the panel servo IDs to match your X and Y ports used on the side car.
It is far more likely that you'll get this to work, then you can look at the diagram and compare to what you've been doing, including running them both with probes to compare how they operate.
Greg McKaskle
|