Thread: Hex key sizes
View Single Post
  #2   Spotlight this post!  
Unread 24-06-2002, 01:21
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
charts in shop tools
Posted by Ken Leung at 02/24/2001 9:20 PM EST


Student on team #192, Gunn Robotics Team, from Henry M. Gunn Senior High School.


In Reply to: Hex key sizes
Posted by Danielle on 02/23/2001 5:16 PM EST:



I don't think I quite understand your question...
Usually Hex keys (allen wrench) are for set screws or socket-headed screws... Is that what you are asking?

You might as well go to your local hardware store and test out which hex key will fit.

About tool charts, I found a good place for them.

In www.shoptools.com under "resource", there are couple of charts you might be interested in.


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.