|
Re: DIO not working in autonomous.
do you know for sure that the switch is working correctly and switching the input the way you want? if so, next time you run the program, open the VI that its in and click on the light bulb in the block diagram. this will allow you to see the values that are being read and sent. [light bulb is highlighted in attached picture] the only other thing i can think of asking is if the LED has/needs a resistor? 330 ohm should do the trick if so. i know the driverstation will reset itself if one of the 5v source pins touches the 0v ground pins, so watch out for that. if all else fails reload the code.
burmeister.twosevennine@gmail.com
__________________
WHAT TIME IS IT? TWO SEVEN NINE!!! [Team B =) ] Awards: 4 Safety, 2 Ind. Design, 2 Xerox, 1 Nat. Champs
2009 Buckeye Semi-Finalists (1014 & 695) || 2008 GLR Safety Award || 2006 GLR Safety Award
2005 Buckeye Regional Champs (67 & 274) & GM Industrial Design Award & Safety Award GLR Quarter Finalist & Xerox Creativity Award & Safety Award National Xerox Creativity Award & Curie Quarter Finalist (1126 & 180)
2004 Buckeye Delphi Driving Tomorrows Technology Award & Quarter Finalist GLR Champs Nationals Curie Division Finalist
2003 GLR GM Industrial Design Award || 2001 National Newton Division Winner & National Champions
2000 MI DaimlerChrysler Team Spirit Award
|