Thread: to team 263..
View Single Post
  #5   Spotlight this post!  
Unread 24-06-2002, 01:24
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Team 263
Posted by Shawn McMahon at 02/24/2001 2:08 PM EST


Student on team #263, Aftershock, from Sachem H.S. and Symbol, Citycorp., Apoge, CA ....


In Reply to: to team 263..
Posted by Anton Abaya on 02/24/2001 4:28 AM EST:



That picture of our robot posted by cad man is our robot before it was complete. It looks much nicer w/ our “spoiler” of a claw. Basically it can go under the barrier and move the bridge from full up to full down (2 ft range of motion). It can pull two goals or the stretcher w/ 150lbs on it over the bridge. It moves too fast to accurately handle so a programmed "low range" button is used if we need to do delicate maneuvers. At full power it can do burnouts across the carpet (we have to be careful of that because its damaging the playing field) and do fun wheelies. :-) We almost always use the low range button. It lets the robot move at 1/3 full speed.


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.