|
Re: DIO not working in autonomous.
You don't mention a pullup resistor on the digital input. You didn't need one last year. Even though your test inicates it's working I would add the pullup.
However, based on your tests, I'd be concerned about using the correct input channel. I'd try switching input channels while leaving the wires in place to see if you have the wrong input. Could be a 1-0 numbering problem.
Also, try switching the led from a screen button, switch ALL the outputs.
__________________
Phil Malone
Garrett Engineering And Robotics Society (GEARS) founder.
http://www.GEARSinc.org
FRC1629 Mentor, FTC2818 Coach, FTC4240 Mentor, FLL NeXTGEN Mentor
Last edited by PhilBot : 30-01-2009 at 09:19.
|