Quote:
Originally Posted by Al Skierkiewicz
Eric,
Any one signal can affect the other signals that are combined. It is unlikely that the noise component would cause problems in your configuration but anything is possible. I still point to the single failure. A defective ground takes out as many as four of your sensors, while individual wires may only take out one. I would like to understand the term "buss" in your configuration. Are you referring to common power supply connections or summing several sensor inputs to one connection?
|
Thank you for all of your help on this issue so far, your expertise is greatly appreciated. We won't summing the signal over one conductor, but using a multi-pole connector (Molex, D-Sub - still deciding) to facilitate wire routing and a implementation of a quick-disconnect system.