Thread: Problems running Default LabView Code Version 3.0
View Single Post
  #1   Spotlight this post!  
Unread 31-01-2009, 15:09
seg9585's Avatar
seg9585 seg9585 is offline
Registered User
AKA: Eric
FRC #4276 (Surf City Vikings)
Team Role: Engineer
  
Join Date: Feb 2006
Rookie Year: 2001
Location: Boeing (Seal Beach, CA)
Posts: 520
seg9585 has a reputation beyond reputeseg9585 has a reputation beyond reputeseg9585 has a reputation beyond reputeseg9585 has a reputation beyond reputeseg9585 has a reputation beyond reputeseg9585 has a reputation beyond reputeseg9585 has a reputation beyond reputeseg9585 has a reputation beyond reputeseg9585 has a reputation beyond reputeseg9585 has a reputation beyond reputeseg9585 has a reputation beyond repute
Problems running Default LabView Code Version 3.0
We are trying to program our robot in Labview and are not having much success:
In earlier versions we were getting motors/sensors to run fine, but when we upgraded to version 3.0, we cannot get any pwm output, even with the default code. LabView seems to deploy fine and we get no errors in the cRio and the Driver Station, but there is no apparent signal from PWMs 1 and 2 (with joystick connected to USB 1).
We applied the firmware upgrade and everything, still with no luck.
Anyone else have similar problems?