Thread: Attaching KoP encoders
View Single Post
  #1   Spotlight this post!  
Unread 04-02-2009, 02:46
DarKCroNo's Avatar
DarKCroNo DarKCroNo is offline
Registered User
FRC #2670
  
Join Date: Dec 2007
Location: Toronto
Posts: 37
DarKCroNo is an unknown quantity at this point
Attaching KoP encoders
I was just wondering how are u supose to attach the encoders found in the KoP? when attaching it to the 1/4 inch axle on the gear box i was woundering how your suppose to attach the axle to the metal hub of the encoder. Are u suppose to use tape or something or like coder pin, set screw etc. although it would destroy the hub.