Quote:
Originally Posted by Alan Anderson
Yes.
Are you certain you have battery power coming from the Power Distribution to the Analog Breakout? Measure on the white WAGO connector on the breakout to make sure. You might have one of the WAGO connections hitting the insulation instead of the conductor on an insufficiently-stripped wire.
(Note that you must use a 20A breaker, not a 5A one.)
|
Yes, we do have power going to the breakout via a 20amp breaker.
Quote:
|
Originally Posted by Russ Beavis
What else is the Driver Station displaying? Enabled/Disabled/No Comms/No Code? What about the RSL state?
|
Enabled, displays No Comms No Code when it first starts up then goes to 00.00v and stays. Does the same thing with autonomous enabled. We have been been running programs on the cRIO since the start of the season. Everything is updated and what not. I just noticed that this was happening the other night and couldn't find anything about it.
Note -- We have been changing out the battery and no change.