|
Re: Labview questions, using motor and pot as a servo
The bechtop test steps should have had you connect the camera to a computer, change the PC IP to 192... and run a utility to image the camera.
An alternative is to change to a compatible IP, open a web browser to 102.168.0.90, log in to the camera, and use the camera's settings editing pages to add an account or FRC for user and FRC for password.
If you can already log into the camera using FRC, FRC, you are done. This utility is by the way a reasonable way to experiment with settings on the camera, but beware of the side effects such as my coworker who set his compression to zero.
Greg McKaskle
|