I'm not sure that the requirement for the relief valve wasn't in the rules last year. Note that this is only for teams using the compressor to pre-pressurize the robot before the match, not teams that have the compressor on board the robot.
What caught my attention, however, was this:
Quote:
|
____ High-Pressure Regulator - must include an on-robot 120PSI max setting) regulator and visible gauge immediately downstream of the compressor and 125PSI relief valve.
|
This is definitely different from previous years and, as far as I can tell, is not required in the rule book. Likely a typo and should refer to the 120psi pressure switch, but I would hate to see an inspector asking why we only have one (60psi) regulator on the robot.
Probably needs a Q&A if it isn't revised shortly.
Thanks for pointing out that the inspection checklist has been published... or at least Rev. A has!
Jason