|
Re: Problems with the RSL
Your description of your connections sounds consistent with the Power Distribution Diagram.
Here are a few things to check on:
1. Is the Digital Sidecar properly connected to the Power Distribution Board? Make sure the Power, 5V, and 6V LEDs light up when power is applied. Make sure that the Wago terminals on the Power Distribution Board and the Digital Sidecar are grabbing the wire and not the insulation, If the wire is not stripped long enough the terminals can grab the insulation.
2. Is the Digital Sidecar connected to the cRIO with the 37 pin cable?
2. Did you try the other Digital Sidecar to verify it is not a hardware problem with the one you are using?
__________________
2007 Wisconsin Regional Highest Rookie Seed & Regional Finalists (Thanks 930 & 2039)
2008 MN Regional Semifinalists (Thanks 2472 & 1756)
2009 Northstar Regional Semifinalists (Thanks 171 & 525)
Last edited by Vikesrock : 09-02-2009 at 17:58.
|