|
Re: Driver Station Digital Input
Jeremy,
Lucky for you that this input is somewhat fault tolerant.
Use an ohmmeter to determine the pin arrangement on your switch. Connect one pole to +5, the other pole to ground and the common to the signal pin.
Mike
__________________
Mike Betts
Alumnus, Team 3518, Panthrobots, 2011
Alumnus, Team 177, Bobcat Robotics, 1995 - 2010
LRI, Connecticut Regional, 2007-2010
LRI, WPI Regional, 2009 - 2010
RI, South Florida Regional, 2012 - 2013
As easy as 355/113...
|