Thread: 8 mm motor shaft to .5 drive shaft adaptor
View Single Post
  #2   Spotlight this post!  
Unread 10-02-2009, 09:24
Bruceb's Avatar
Bruceb Bruceb is offline
Registered User
FRC #0706 (Cyberhawks)
Team Role: Mentor
  
Join Date: Jan 2008
Rookie Year: 2004
Location: Merton, wi
Posts: 614
Bruceb is a splendid one to beholdBruceb is a splendid one to beholdBruceb is a splendid one to beholdBruceb is a splendid one to beholdBruceb is a splendid one to beholdBruceb is a splendid one to beholdBruceb is a splendid one to behold
Re: 8 mm motor shaft to .5 drive shaft adaptor
Find a piece of 3/4 round steel. Drill it with an 8mm drill through then from one end half way through with a .5 in drill. Make this thing about 1.5 to 2 in long. Drill and tap for four 1/4-20 set screws. Grind flats on your shafts where the set screws contact them and you will not need the keyway.
Bruce