Quote:
Originally Posted by HarryScheiner
3) Could you explain this? I'm not sure I understand.
|
What I mean is, have you done the following:
-Flipped the DIP switch on the cRIO that says "Console"
-Connected the 9-pin serial port on the cRIO to your computer (either a serial or USB port, depending on what you have available) with a null-modem cable
-Opened a terminal in Workbench (from the menubar Window -> Show view -> Terminal) or connected via some other program like HyperTerminal or PuTTY. Regardless of what you use, the settings should be:
connection type - serial
9600 baud,
8 data bits,
1 stop bit,
no parity,
no flow control
-Watched the cRIO's boot messages on the terminal to see if it's outputting any errors