Thread: Creating the trailer hitch
View Single Post
  #6   Spotlight this post!  
Unread 10-02-2009, 23:36
GUI GUI is offline
Registered User
AKA: Gary
FRC #4183 (Bit Buckets)
Team Role: Mentor
  
Join Date: Nov 2006
Rookie Year: 2006
Location: Tucson, AZ
Posts: 229
GUI is a splendid one to beholdGUI is a splendid one to beholdGUI is a splendid one to beholdGUI is a splendid one to beholdGUI is a splendid one to beholdGUI is a splendid one to beholdGUI is a splendid one to behold
Send a message via Yahoo to GUI
Re: Creating the trailer hitch
Yes, and the "u shaped piece of metal with holes on it" is made by cutting out a 7" long section of the kit frame c channel with one of the pre-drilled 1/4" holes in the center. If you cut 7" off the stock end of one of the channels the hole will be in the proper location (unless your kit frame is different than ours, you never know so double check).