[T3HN3RDY1]

Okay, so here's the deal. I'm the programmer for the robot for team 2925 and I've been trying everything I can think of but cannot get our compressor to run. I'm sure that I've labeled all of the channels/inputs/etc. correctly. In my Robot Main VI I have the Compressor Open VI on the outside of the while loop, wired to the Compressor Start VI, also on the outside of the while loop. On the inside I have the Compressor Enabled VI, wired to the Compressor Stop and Close VI's on the outside. I'm completely new to LabView and have tried everything I can think of to get this to work. ANY help would be very, very much appreciated as we're quickly running out of time.

As a side note, the mentor and wiring guys say that the compressor and solenoid are hooked up properly.

Thank you to anybody that helps!

Also, my mentor asked me to mention in this post that the light on our spike is amber colored, not green. We don't know what this means, if it's bad or just normal, so information on that would be helpful.