Thread: Problem Getting Victors to run with the new control system
View Single Post
  #1   Spotlight this post!  
Unread 12-02-2009, 20:33
Boommaster713's Avatar
Boommaster713 Boommaster713 is offline
Registered User
FRC #0932 (Circuit Chargers)
Team Role: Driver
  
Join Date: Dec 2008
Rookie Year: 2008
Location: Tulsa, OK
Posts: 11
Boommaster713 is an unknown quantity at this point
Problem Getting Victors to run with the new control system
My team's programmers are having a problem getting victors to respond to any commands from labview
as of this afternoon they got a single signal to victors but they were not able to get them to run just sputter

we have all updated software and reimaged the cRio with the most current version today rebooted and still couldnt get the victors to respond to any programms on a regular basis

i do not think it is a wiring issue in that i have cross checked all wires and PWMs with jaguars and the jaguars run with no problems but when the wires are put into the victors and programmed using the victor sub command they do nothing

has any other teams had this situation and if so how did you solve this problem

TEAM 932 appreciates any input that could help in this situation