Thread: Controlling 2 pneumatic valves w/ 1 spike
View Single Post
  #2   Spotlight this post!  
Unread 14-02-2009, 12:24
Urban Hawk Urban Hawk is offline
Head of R&D and Head of Scouting
FRC #1886
Team Role: Scout
  
Join Date: Jan 2008
Rookie Year: 2007
Location: Urbana, maryland
Posts: 118
Urban Hawk is infamous around these partsUrban Hawk is infamous around these partsUrban Hawk is infamous around these parts
Re: Controlling 2 pneumatic valves w/ 1 spike
yes it is legal.

Quote:
<R48> Each power-regulating device (speed controller or relay module) shall control one and only one electrical load (motor, actuator or compressor).
A. Exception: Multiple low-load, pneumatic solenoid valves may be connected to a single relay module. This would allow one relay module to drive multiple pneumatic actions. No other electrical load can be connected to a relay module used in this manner.
as for connecting them just attach the 2 positive wires to the same spot on the spike and do the same with the negatives.
__________________
FEAR THE HAWK!!!
Last edited by Urban Hawk : 14-02-2009 at 12:31.