|
Re: Autonomous help
As I understand it, you want your sensor code and your motor code to be running at different frequencies (to check your sensors more often).
Have you tried using two while loops running in parallel? One of the nice things about labview is that you can run two loops at the same time. Just pass the angle variable into the motor loop. That way you can have the two loops running at different frequencies.
__________________
MORT 11
-2005 New Jersey Regional Chairman's Award Winner
-2006 Palmetto Regional Winner
-2007 New York Regional Delphi Driving Tomorrow's Technology Award
-2008 New Jersey Regional Finalist, Chesapeake Regional Winner, Championship Event Overall Top Seed
HB 2399
-2009 Buckeye Regional Delphi Driving Tomorrow's Technology Award, Pittsburgh Regional GM Industrial Design Award
|