Thread: Grooving wheelchair wheels
View Single Post
  #5   Spotlight this post!  
Unread 24-06-2002, 02:00
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Grooving wheelchair wheels
Posted by Dan at 03/09/2001 6:08 AM EST


Other on team - from Carnegie Mellon sponsored by -.


In Reply to: Grooving wheelchair wheels
Posted by Patrick Dingle on 03/08/2001 6:35 PM EST:



I'm not sure what the rules are, but I found some awesome cogged v-belt that has some huge teeth. It's not timing belt, but it looks like it. It's cogged so it has a smaller min. bend radius. Check out www.mscdirect.com. It's also a good way to add to your wheel diameter for speed (I found 1/2" thick and 7/8" wide belts.)
Dan


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.