[BurtGummer]

I've been using really simple compressor labview code that I've seen on some other threads.

It's really odd, because when I disconnect the PWM cable from the DIO the compressor turns on for a split second. And if I keep it REALLY loose on the pins, like holding it barely on the pins, the compressor will keep running, but the PWM cable gets REALLY hot. The PWM cable I'm referring to is the one for the pressure sensor, not the relay/spike.

The pins I am connecting it too are the PWR and (-) pins, which are the middle, and outermost/closest to the edge pins. if you have the 3 pins like this " " " we are hooking the wires here " 0 0 the 0s representing our connections. This is viewed as the parallel port being at the top, and the RSL at the bottom.

I read in another post the it should be hooked up like 0 " 0 but I have no idea.