Thread: "Allocating channel or module that is out of range"
View Single Post
  #11   Spotlight this post!  
Unread 16-02-2009, 12:31
Parthenon Parthenon is offline
Registered User
FRC #1325 (Inverse Paradox)
Team Role: Programmer
  
Join Date: Jan 2009
Rookie Year: 2004
Location: Mississauga
Posts: 10
Parthenon is an unknown quantity at this point
Re: "Allocating channel or module that is out of range"
We've found a solution

We discovered the code wasn't compiling properly, so after we deleted the PPC603gnu folder, it began compiling again. This removed the error.

Secondly we plugged in the solenoid module into module 8. Initially I didn't think it needed power, but it actually did, so we hooked up a wago connector to it in 12v input on the power dist. board and everything was working