Thread: [FTC]: LABView Servo Problem
View Single Post
  #1   Spotlight this post!  
Unread 16-02-2009, 15:14
Geek_Girl Geek_Girl is offline
Extant Female Geek
AKA: Kathy Garcia
FRC #0842 (Falcon Robotics)
Team Role: Programmer
  
Join Date: Sep 2007
Rookie Year: 2008
Location: Phoenix
Posts: 10
Geek_Girl is an unknown quantity at this point
[FTC]: LABView Servo Problem
Our team is using LABView, and we cannot get the servos to function properly.

No matter how the servo is controlled(same controller as motors or seperate, using buttons or joysticks) it only moves a few degrees when the button/joystick is pressed. I have tried connecting the servo value on FTCMoveServos to a constant, anything from 0 to 255, but it only moves within those few degrees.

Oddly enough, on an earlier test robot that we made, the same servos and almost the same code worked fine.

Any suggestions?
Reply With Quote