Thread: 267 Looking for kissin' cousins! Off Ramp Balancers Reply!
View Single Post
  #12   Spotlight this post!  
Unread 24-06-2002, 02:35
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
on theory, 2
Posted by Ken Leung at 03/20/2001 3:43 PM EST


Student on team #192, Gunn Robotics Team, from Henry M. Gunn Senior High School.


In Reply to: 1 goal or 2?
Posted by bill whitley on 03/20/2001 3:27 PM EST:



on theory, 2 goals...

However, it is extremely hard to control the goals from falling over to the other side...

That's why it take Heatwave and Metal in motion to do it in KSC.

Usually what ended up happening, is the two goals is being setup in front of those big arm robots, and there are usually a little trouble lining up the two goals for the bridge.

Then, it take a lot of traction to push two goals up the bridge, and sometimes when there aren't enough traction, the wheels keep spinning on the carpet doing nothing. Then it take couple of backing up to build up the momentum, spending all those effort until suddenly the goals went too far and fall on the other side of the bridge.


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.