Thread: 267 Looking for kissin' cousins! Off Ramp Balancers Reply!
View Single Post
  #13   Spotlight this post!  
Unread 24-06-2002, 02:35
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: on theory, 2
Posted by bill whitley at 03/20/2001 10:16 PM EST


Student on team #70, Auto City Bandits, from Powers Catholic High School and Kettering University.


In Reply to: on theory, 2
Posted by Ken Leung on 03/20/2001 3:43 PM EST:



: on theory, 2 goals...

: However, it is extremely hard to control the goals from falling over to the other side...

: That's why it take Heatwave and Metal in motion to do it in KSC.

: Usually what ended up happening, is the two goals is being setup in front of those big arm robots, and there are usually a little trouble lining up the two goals for the bridge.

: Then, it take a lot of traction to push two goals up the bridge, and sometimes when there aren't enough traction, the wheels keep spinning on the carpet doing nothing. Then it take couple of backing up to build up the momentum, spending all those effort until suddenly the goals went too far and fall on the other side of the bridge.

At WMR, I watched Beatty do it, I never saw them fail, never saw them struggle, or spin the wheels, near perfection...

Bill
Team #70


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.