Thread: Traction is Key!!!!
View Single Post
  #3   Spotlight this post!  
Unread 24-06-2002, 02:37
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: Traction is Key!!!!
Posted by Andrew wyatt at 03/21/2001 1:02 AM EST


Other on team #524, Alpha Omega Robotics, from South High School.


In Reply to: Re: Traction is Key!!!!
Posted by Deej- T190 on 03/20/2001 3:01 PM EST:



: : As the title states I believe that traction is key if you have any chance at winning. Our first robot that we built had the stock straight out of the box 6" wheelchair wheels on them. We had very little traction going up the ramp and so we made our ramp extender feature of the robot act as a counter balance to make it up the incline. But that didn't work because we ended up tipping ourselves over a few times. Fortuanately we righted our selves in enough time to get into the endzone but lost major points for our alliance.

: : Our remedy: All four wheels were burned with a woodburner with a space in between all of the burns. If you do this make sure you do it in a well ventilated area though!!! The wheels give off alot of smoke when being burned.

:
: another way of making the treads is to use a vertical mill and make the grooves like that (if you have the time). Thats what we did here on T190, and no problems with traction at all....

Thats what we did here at team 524, also. we managed to get too much traction from our wheels, making the breakers trip every time we take a turn too tight.


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.