Thread: TO All The CAD DESIGNERS
View Single Post
  #8   Spotlight this post!  
Unread 24-06-2002, 02:41
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: TO All The CAD DESIGNERS
Posted by Jason Iannuzzi at 03/22/2001 4:00 PM EST


Engineer on team #11, Marauders, from Mt. Olive HS. and BASF, Rame Hart, CCM.


In Reply to: TO All The CAD DESIGNERS
Posted by Gabe on 03/21/2001 10:29 PM EST:



Two of us did most of the design.

I use Solidworks 2001. The other engineer uses *gasp* Anvil 4.0. Anvil is a pretty old 2D system, but it's quite simple to use and powerful if you know what you're doing. Solidworks is great, but large assemblies can really bog down my system.

__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.