Thread: TO All The CAD DESIGNERS
View Single Post
  #10   Spotlight this post!  
Unread 24-06-2002, 02:41
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: TO All The CAD DESIGNERS
Posted by ChrisH at 03/27/2001 12:02 AM EST


Engineer on team #330, Beach 'Bots, from Hope Chapel Academy and NASA JPL, J & F Machine, Raytheon, et al.


In Reply to: TO All The CAD DESIGNERS
Posted by Gabe on 03/21/2001 10:29 PM EST:



I used the AutoCad R14 they gave us a couple of years ago. I tried to install Inventor, but it declined to lower itself to my trusty P2 166.

I would prefer to use Unigraphics or Catia but my employer would frown on that. Our other mechanical designer uses pencil and paper.

For some things I use a pencil too. But I find it easier to visualize in 3D. It also helps to keep all of the holes aligned. Especially when parts are being made at different places

Chris Husmann
Team 330 the Beach'Bots


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.