Thread: Gyro interface to software
View Single Post
  #1   Spotlight this post!  
Unread 24-06-2002, 02:50
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Gyro interface to software
Posted by Erik at 03/26/2001 1:08 PM EST


Engineer on team #381, Trenton Tornados, from Trenton High School and Princeton University.



Can someone give me a heads up on how to interface the gyro with software, how to set up a variable to act as the input, is it digital or is it an analog signal, and if so is a simple if statement htat checks to see the value of the analog variable sufficient to use as a conditional starter for some automatic control of the robot? Any help and guidence appreciated.

-engineer forced to program


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.