[Burmeister #279]

the way we wanted it to be was a table of values that could be displayed and edited in the front panel such as:

___|Start Time|__|X Value|___|Y Value|___|Lift pos|__|Door Pos|__
------------------------------------------------------------------
1__| 2500[ms] |__|__-1__|___|__+1__|___|up[true]|__|open[F]|__
------------------------------------------------------------------
2__| 7500_____|__|__0__|___|_-1____|___|up[true]|__|open[F]|__
------------------------------------------------------------------

etc. but it would have to be dynamic in such a way that we can add several lines, up to at most 10, but also have as little as 1 line. as i said, this would be displayed on the front panel so we can say here is exactly what it will do at this point. we'd only be reading from these values and not from the DS or computer. the time i was talking about is the autonomous mode time which is kept track of by a get tick count in the DS vi's and fed through to the match info.

thanks

[edit] the switches i was referring to are a set of 5 switches on the driverstation which have already been coded to work but we're still stuck on getting the values into the function.