Thread: could any engineers help me out please?
View Single Post
  #4   Spotlight this post!  
Unread 24-06-2002, 02:55
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: I am an engineer...
Posted by Stephen Riley at 03/27/2001 11:35 PM EST


Engineer on team #419, RAMBOTS, from Wentworth Institute of Technology and sponsors? what are they?.


In Reply to: I am an engineer...
Posted by Thomas A. Frank on 03/27/2001 1:39 PM EST:



Thank you both for the information, it has already been put to good use, but tom i have a question for you : Do you know of any good company or model of SSR or any of the above that i asked about that would be good to regulate the temp for a soldering iron tip to about 300 C ? thanks once again.

Steve
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.