Thread: optical sensor
View Single Post
  #4   Spotlight this post!  
Unread 24-06-2002, 02:55
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Yer Right - 12 V :-(
Posted by Lloyd Burns at 03/28/2001 6:27 PM EST


Engineer on team #188, Woburn Robotics, from Woburn Collegiate and TorDistSchoolBrd, ScotiaBank. OntPwrGen, Enbridge.


In Reply to: Re: optical sensor
Posted by Travis Hoffman on 03/27/2001 10:18 PM EST:



: One of the wires goes to ground, one to the +5 V pin,

: The optical sensor runs on 12 VDC. Tap the power for the device from the 20A Robot Controller circuit breaker.

: Travis

__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.