View Single Post
  #9   Spotlight this post!  
Unread 24-06-2002, 03:17
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
 
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Mating gears

Posted by Matt Reiland at 04/11/2001 11:12 AM EST


Engineer on team #226 from Troy, Troy Athens and General Motors CRW.


In Reply to: Gear Data... One more time...
Posted by Joe Johnson on 04/09/2001 1:14 PM EST:



I hope this isn't way out there but this year were you allowed to use some of the gears (6)towards the 'timing pully's' allowed in additional hardware or did you have to make a gear that mated to the BOSCH? I am not sure about what small parts sells to mate to the pinions, I guess I have to look into it a little more.

My electrical backround is failing me right now

Thanks anyone who can help


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.