Thread: 0.502" Drill bit?
View Single Post
  #3   Spotlight this post!  
Unread 10-04-2009, 14:41
MrForbes's Avatar
MrForbes MrForbes is offline
Registered User
AKA: Jim
FRC #1726 (N.E.R.D.S.)
Team Role: Mentor
  
Join Date: Feb 2006
Rookie Year: 2006
Location: Sierra Vista AZ
Posts: 6,017
MrForbes has a reputation beyond reputeMrForbes has a reputation beyond reputeMrForbes has a reputation beyond reputeMrForbes has a reputation beyond reputeMrForbes has a reputation beyond reputeMrForbes has a reputation beyond reputeMrForbes has a reputation beyond reputeMrForbes has a reputation beyond reputeMrForbes has a reputation beyond reputeMrForbes has a reputation beyond reputeMrForbes has a reputation beyond repute
Re: 0.502" Drill bit?
If you don't need a precise fit, you can waller out the hole with the drill

If you do need a precise fit, a hand reamer is the way to go. You can buy them in exact sizes, or you can get adjustable reamers. We're lucky, the fab shop we use on Ft. Huachuca has a nice set of each, from very small to an inch diameter.