View Single Post
  #16   Spotlight this post!  
Unread 11-04-2009, 12:18
Dick Linn's Avatar
Dick Linn Dick Linn is offline
Registered User
no team (Synergy)
 
Join Date: Jan 2003
Rookie Year: 2001
Location: Midlothian, VA
Posts: 679
Dick Linn has a reputation beyond reputeDick Linn has a reputation beyond reputeDick Linn has a reputation beyond reputeDick Linn has a reputation beyond reputeDick Linn has a reputation beyond reputeDick Linn has a reputation beyond reputeDick Linn has a reputation beyond reputeDick Linn has a reputation beyond reputeDick Linn has a reputation beyond reputeDick Linn has a reputation beyond reputeDick Linn has a reputation beyond repute
Send a message via AIM to Dick Linn
Re: 0.502" Drill bit?

Team 975 once had to hone out a pair of 5/8" bore flanged steel sprockets to fit a 16 mm shaft. I figure it was probably .004" or so. We used a 5/8" shaft in a drill press and a lot of valve grinding compound. It took a lot of time but the fit was beautiful. Next time that was needed, we just spun the shafts and sanded them down to fit. Much easier.
__________________
Richard Linn

Proud father of Marine LCpl. Karl R. Linn
Co-founder Team 975
KIA, Iraq 1/26/2005