Thread: uni-casters?
View Single Post
  #4   Spotlight this post!  
Unread 24-06-2002, 03:46
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: uni-casters?
Posted by Matt Reiland at 04/20/2001 12:46 PM EST


Engineer on team #226 from Troy, Troy Athens and General Motors CRW.


In Reply to: uni-casters?
Posted by Jimmy Holmes on 04/20/2001 11:37 AM EST:



Team 111 had some really sweet ones that used rubber o-rings on each of the little rollers, we used 1" diameter washers fo ours but the principle is the same. If someone from 111 can chime in it looked like theirs were two 1/4" circular plates sanwiched together with an area for the shafts milled on each before they were sandwiched, I also saw a few that looked like the rollers were made out of rubber but I don't know what they used out of small parts to make them. All in all they work great I can send some pictures of wildstangs that they let me take if you need em
__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.