Thread: Questions about crab/swerve drive.
View Single Post
  #13   Spotlight this post!  
Unread 26-04-2009, 18:24
IceStorm IceStorm is offline
Mentor FRC 5046, FTC 8688
AKA: Chad
FRC #5046 (Jacked Up Jackets)
Team Role: Mentor
  
Join Date: Jan 2009
Rookie Year: 2009
Location: Michigan
Posts: 136
IceStorm is a glorious beacon of lightIceStorm is a glorious beacon of lightIceStorm is a glorious beacon of lightIceStorm is a glorious beacon of lightIceStorm is a glorious beacon of light
Send a message via AIM to IceStorm Send a message via Yahoo to IceStorm
Re: Questions about crab/swerve drive.
I seen the mcmaster one's but didn't even look at the size after i seen they were over the 1 item can be no more than cost factor.

Idealy you would want a through bore type i think so that you could do the coaxial setup with it. And If I'm right about the US Digital encoders they are a 4 conductor.

So anyone know where to get a 1/2" ID through bore 4 conductor slip ring and keep the cost down on it. Most of the ones i've found searching show them being able to handle RPM's in the hundreds which would never happen.