View Single Post
  #1   Spotlight this post!  
Unread 29-04-2009, 14:25
Gerry_TECH Gerry_TECH is offline
Registered User
no team
 
Join Date: Apr 2009
Location: Ottawa, Canada
Posts: 14
Gerry_TECH is an unknown quantity at this point
Arrow Scorbot Robotics cell with table top Conveyor

Hi Folks,

I just wanted to show you all my Scorbot setup with some custom conveyor work that I put together using Industrial Flex-link conveyor chain. I've been using several models of the Scorbot series robots for more than five years now, talk about fun.

I finally got my controller-A interfaced properly and running very smoothly with ATS ACL software.

The Scorbase software for the ER-III controller is ok too, but I prefer using the controller-A ACL software, so on that note the ER-III connected to this controller is essentially a mod to an ER-V robot.

My plan is to mod a ER-4PC that I have to an ER-V Plus and run it with the controller-A unit as well.

I'm also doing some work with CRS 265 robots, fun fun!

Scorbots are Awesome!!

-Gerry



Here's a few shoots from the building phase.



The yet to be moded ER-4PC on the Flex-Link Conveyor table






This is my Controller-A unit running ACL software



My ER-III robot getting ready to be interfaced to the ACL controller



Some New Flex-Link chain I just got to build a new conveyor table with the Drive unit under the table for Continuous Flow, as compared to the previous model shown above.

Last edited by Gerry_TECH : 29-04-2009 at 16:28.