Thread: What is your favorite method for attaching gears to shafts?
View Single Post
  #5   Spotlight this post!  
Unread 24-06-2002, 04:00
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Re: I agree with Dr Joe, but there are other ways
Posted by Jason Iannuzzi at 05/01/2001 10:13 AM EST


Engineer on team #11, Marauders, from Mt. Olive HS. and BASF, Rame Hart, CCM.


In Reply to: I agree with Dr Joe, but there are other ways
Posted by ChrisH on 04/30/2001 5:20 PM EST:



I think Woody needs to revise his famous kickoff statement regarding fastening methods.

When it comes to drive trains, "Pins AND set screws suck!" is a more fitting warning.

For the past two years, we have had the most success with welding everything in place. It's a rather permanent solution, but it's quick, it's easy, and it holds up very well. I'd say it's the best option for teams with fewer resources.

__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.