Thread: What is your favorite method for attaching gears to shafts?
View Single Post
  #1   Spotlight this post!  
Unread 24-06-2002, 04:00
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
square holes
Posted by Ken Patton at 04/30/2001 10:58 PM EST


Engineer on team #65, The Huskie Brigade, from Pontiac Northern High School and GM Powertrain.


In Reply to: What is your favorite method for attaching gears to shafts?
Posted by bill whitley on 04/30/2001 3:51 PM EST:



For tight packaging, we use wire EDM'd square holes. For areas where packaging is not a problem, we use flange mounts.

Ken



__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.