Thread: Spur Gears Again
View Single Post
  #1   Spotlight this post!  
Unread 24-06-2002, 04:03
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Spur Gears Again
Posted by Matt Reiland at 05/04/2001 3:59 PM EST


Engineer on team #226 from Troy, Troy Athens and General Motors CRW.



To all who are considering making their own transmissions next year:

Small parts has told me they will carry some mating 0.7 MOD gears next year if the rules don't change to allow teams to buy them from any place they want. My question is to all of you what tooth counts are preferable for them to stock if they can only carry 2 or 3 different sizes? I asked them to do this since many teams don't have access or funds to a shop that can do a very small batch of custom gears. I happen to be lucky enough to live here in MI where there are about 100 of them but it is different in other areas of the country.

Thanks for your reply's

Matt


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.