Thread: Any ideas?
View Single Post
  #1   Spotlight this post!  
Unread 23-05-2009, 20:06
kajeevan kajeevan is offline
Registered User
FRC #0188 (blizzard)
Team Role: Mechanical
  
Join Date: Oct 2007
Rookie Year: 2006
Location: woburn
Posts: 40
kajeevan has much to be proud ofkajeevan has much to be proud ofkajeevan has much to be proud ofkajeevan has much to be proud ofkajeevan has much to be proud ofkajeevan has much to be proud ofkajeevan has much to be proud ofkajeevan has much to be proud ofkajeevan has much to be proud of
Any ideas?
I'm working on a project were i need to mount a DeWALT 2-speed drill. The application of this drill is for a drive train direct driving a wheel so secure mounting is needed. I took off the case to take a look inside and the case seems to be needed to hold the gearbox together but i will cut the handle off. I have a couple of solutions but I am wondering if anyone else has a better one before I start cause funding is very much limited so I wanted the best and simplest method possible. So anyone with any idea of mounting this it would be much appreciated.

This is the link to the Drill:

http://www.canadiantire.ca/AST/brows...4V%2BDrill.jsp