Thread: Chief Delphi: where'd you get that amazing conveyor belting?
View Single Post
  #2   Spotlight this post!  
Unread 24-06-2002, 04:13
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Jason Industrial
Posted by Joe Johnson at 05/16/2001 8:49 AM EST


Engineer on team #47, Chief Delphi, from Pontiac Central High School and Delphi Automotive Systems.


In Reply to: Chief Delphi: where'd you get that amazing conveyor belting?
Posted by Joe Taylor on 05/15/2001 3:00 PM EST:



I contacted Motion Industries and asked them for belt suppliers. They put me in touch with Bill at Jason Industrial (800.527.1247). They bent over backwards to get me belts that would work.

By the way, this company has a wide variety of belt solutions, but they carry very little stock on hand. There factory (in NJ I think) can take 3 weeks to fill an order, so... order early.

FYI the belt we used was backed with 1/4 inch red Latex . The Latex is molded right into the belt. We never had a belt that the Latex seperated from the rest of the belt. We loved them after we learned that we had to keep them clean if we wanted to maintain the best grip possible on the carpet.

Good luck.

Joe J.


__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.