Thread: What was the most innovative feature this year?
View Single Post
  #1   Spotlight this post!  
Unread 24-06-2002, 04:17
archiver archiver is offline
Forum Archival System
#0047 (ChiefDelphi)
  
Join Date: May 2001
Location: Pontiac, MI
Posts: 21,214
archiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond reputearchiver has a reputation beyond repute
Not too hard to do
Posted by Andy Baker at 05/24/2001 11:09 AM EST


Engineer on team #45, TechnoKats, from Kokomo High School and Delphi Automotive Systems.


In Reply to: How in the world..
Posted by Gui Cavalcanti on 05/23/2001 5:09 PM EST:



... but it's hard to explain. We made a circular piece that fastened to the FP motor and clamped on the back of the drill motor. The circular piece had holes in the sides, where we could route the drill motor wires out. Also, these holes would let us see in and check the mechanical connection of the coupling.

Again... it's kinda hard to explain. Once the design is published, you'll see it wasn't that difficult to wire the motors.

Andy B.



__________________
This message was archived from an earlier forum system. Some information may have been left out. Start new discussion in the current forums, and refer back to these threads when necessary.