|
Re: pic: FP Gearbox (KOP Gears - 2)
Quote:
Originally Posted by rc_cola1323
We didn't exactly "purchase them" they are kinda homemade but it doesn't take any efforts at all to pop out 50+ in about a few hours.
For the 3/8ths bearings, we bought these supplies from mcmaster carr:
-1/2 bore bearings (6383K234)
-1/2 OD - 3/8 ID Bushing (6338K414)
-One 3/8th Hex broach (2875A19)
All we did is place the bushing over the bearing. Then we broached and pressed the bushing in at the same time. They all worked great, We made about 100+ bearings this season. It makes life 10x easier not to have to lathe down the ends, we do have access to one, but we found it easier to interface everything with hex.
-RC
|
I'll also vouch for this technique. However we never really needed to "press" the bushings into the bearings, they should kind of slide in snugly.
__________________
MORT (Team 11) '01-'05 :
-2005 New Jersey Regional Chairman's Award Winners
-2013 MORT Hall of Fame Inductee
NUTRONs (Team 125) '05-???
2007 Boston Regional Winners
2008 & 2009 Boston Regional Driving Tomorrow's Technology Award
2010 Boston Regional Creativity Award
2011 Bayou Regional Finalists, Innovation in Control Award, Boston Regional Finalists, Industrial Design Award
2012 New York City Regional Winners, Boston Regional Finalists, IRI Mentor of the Year
2013 Orlando Regional Finalists, Industrial Design Award, Boston Regional Winners, Pine Tree Regional Finalists
2014 Rhode Island District Winners, Excellence in Engineering Award, Northeastern University District Winners, Industrial Design Award, Pine Tree District Chairman's Award, Pine Tree District Winners
2015 South Florida Regional Chairman's Award, NU District Winners, NEDCMP Industrial Design Award, Hopper Division Finalists, Hopper/Newton Gracious Professionalism Award
|