[marccenter]

This VEXnet test program builds on the first.
During autonomous, Motor/Servo in position 1 , formerly position 8, cycles every one-half second and a print statement happens every one half second until the stop button is pressed. The system can be restarted if the start button in digital input port 5 is pressed.
During operator Control, Motors in position 1 and 2 are set up in tank mode and respond to the transmitter CH4 and CH1. A print statement also is issued every one second. The system can be stopped by pressing a switch that is connected to position 6, but not restarted until VEX controller is power cycled.
Autonomous print statement cannot be seen using EasyC Competition Software Switch from in EasyC - Vex Robotics knows about the issue.
The autonomous print statement works with the field controller system
I have from OCCRA.