Thread: how to build a VEX programming module
View Single Post
  #71   Spotlight this post!  
Unread 19-11-2009, 15:19
essence25 essence25 is offline
Registered User
no team
  
Join Date: Nov 2009
Location: USA
Posts: 2
essence25 is an unknown quantity at this point
Re: how to build a VEX programming module
Now if I have a rs232 to TTL converter that has the following pinouts:

GND
RX->
TX<-
VCC 3-5v

and I'm using a real RS232 pc port. Where do I Connect pins 4-CTS & 6-RTS from the vex programming port? The TTL converter does not have these...

Do I connect them directly to the serial port ? Does the TTL converter only need the TX/RX ports to go through it?

I dont use a USB to RS232.

thanks

Last edited by essence25 : 19-11-2009 at 15:36.
Reply With Quote