|
Re: NXT Brick clicks - reset button pushed...still clicking
Similar to the advice you've already received, the clicking indicates that the processor is waiting for a firmware download. This is usually caused by an interrupted download of FW. The solution is usually to do the download again.
If the download tool does not list the brick as being ready for download, try pulling a battery on the brick, leaving it out for five seconds or so, then reinserting. If that isn't enough, push the recessed reset button for around ten seconds. When the brick shows up in the format list, download a firmware.
It has been awhile since I've had to rescue a brick, so if my memory of the process isn't accurate enough, search sites such as NXTasy.org or TheNXTStep.blogspot.com. They may have the documented steps.
Greg McKaskle
|