Thread: G Code with a Mill
View Single Post
  #8   Spotlight this post!  
Unread 22-12-2009, 18:11
nighterfighter nighterfighter is offline
1771 Alum, 1771 Mentor
AKA: Matt B
FRC #1771 (1771)
Team Role: Mentor
  
Join Date: Sep 2009
Rookie Year: 2007
Location: Suwanee/Kennesaw, GA
Posts: 835
nighterfighter has a brilliant futurenighterfighter has a brilliant futurenighterfighter has a brilliant futurenighterfighter has a brilliant futurenighterfighter has a brilliant futurenighterfighter has a brilliant futurenighterfighter has a brilliant futurenighterfighter has a brilliant futurenighterfighter has a brilliant futurenighterfighter has a brilliant futurenighterfighter has a brilliant future
Re: G Code with a Mill
I got bored, so I decided to write this up, hopefully once our mill gets working, I can try it on a wax block.
http://img707.imageshack.us/img707/3061/diamonds.jpg

You can't see it in the picture, but the cuts are different depths...The inner-most circle is the highest, and then each one outside it descends by .25".

I have a quick question about it, will the cuts be too close, and overlap each other?